FIRST THINGS FIRST:

♡ It is recommended to make the borax (activator) solution BEFORE before opening your slimes.
♡ Wash hands before touching your slime.
♡ Test the consistency of your slime because it may be sticky from shipping.
♡ DO NOT EAT THE SLIME. IT IS NOT EDIBLE. KEEP AWAY FROM PETS & SMALL CHILDREN.

HOW TO: SLIME ACTIVATOR

Activator is used to "activate" or in better terms, "make slime not sticky".

♡ Add 1/2 TSP (lighter solution) or 1 TSP (stronger solution) borax powder (provided in your package) & add to 1 cup of warm water.
♡ Mix until all of the borax dissolves in the water.
♡ First rub solution onto hands & knead the slime, if the slime is still sticky, you can add VERY SMALL AMOUNTS of solution onto slime - I would personally recommend using a spray bottle or plastic dropper.
♡ Knead until desired consistency is achieved.

TIPS FOR TYPES OF SLIME

HARD

This usually doesn't happen unless it is cold. Let your slime sit in a warm area to soften up. If it is still stiff you can add lotion to white glue based slime and glycerin to clear based slime.

STICKY

This happens more often. Please refer to how to use activator above.

BEADS/FOAM FALLING

If the beads are falling out of the slime it is most likely due to overactivation (meaning you added too much activator solution). Let slime sit for a couple days. These slimes are not for everyone & should be pulled and played with delicately.

NOT INFLATING

A lot of this is due to technique. Make sure slime is fully activated. Pull in a quick & swift motion to capture air bubbles. Over time it should get bigger & sizzly. Please note *inflation size varies.

GENERAL SLIME CARE:

Slime does not last forever, but you can give it a long happy life, if you take good care of it.

♡ Wash your hands before playing with your slime, & make sure to clean the surface you will be using to avoid any dirt/bacteria from getting stuck in your slime.
♡ Keep slimes in a cold place. I would recommend the fridge for CLEAR SLIMES ONLY.
♡ ALWAYS keep your slimes in their containers & close lids tightly.